Brake Light Switch, From 12.06

Brake Light Switch, from 12.06

• Use only new type brake light switches.

• The most visible distinguishing feature is the new lighter colored end of the push rod head- A -.





Removing

- Remove trim on driver's side

- If necessary remove footwell vent

- Pull connector off brake light switch.

The brake light switch may be removed only while operating rod is pressed in (brake pedal is not operated), or the locking mechanism of the brake light switch will be damaged.

- Remove brake light switch by rotating 45 degrees toward left.

Installing, adjusting and locking

Before installing the brake light switch, grease the lighter colored end of the push rod head with polycarbamide grease (G 052 142 A2).

• The brake light switch must not be operated while the brake light switch is being installed. The brake pedal may only come into contact with the push rod head of the brake light switch during the whole installation process.

- Guide the brake light switch through the assembly aperture - arrow 1 - and push it with the push rod head against the brake pedal. Then turn the brake light switch through 45 degrees to the right - arrow 2 - until it noticeably engages.





- Fit brake light switch connector.

- Check function of brake light.

- Install footwell vent.