Oil Separator

Oil Separator

Special tools, testers and auxiliary items required

• Torque wrench 5-50 Nm (VAG 1331)

Removing

- Remove the noise insulation.

- Remove the bolts - 9 through 1 - and remove the oil separator.





CAUTION!
Risk of contaminating lubricating system.

• Seal the opening with a clean cloth.

Installing

• Always replace the gaskets and seals.

• Secure all hose connections using hose clamps appropriate for the model type.

Install in reverse order of removal. When doing this note the following:

- Tighten the bolts - 1 through 9 - in sequence.





• Tightening specification: 9 Nm.