Drive Axle Assembly Overview, with CV Joint VL107, Installed on Stub Shaft

Drive Axle Assembly Overview, with CV Joint VL107, Installed on Stub Shaft





1 Outer Constant Velocity (CV) joint

• Replace only as complete unit.

• Removing, refer to --> [ Removing the Outer Constant Velocity (CV) Joint ] Drive Axle, with CV Joint VL107 Installed on Stub Shaft

• Installing: Drive CV joint onto axle shaft until seated using a plastic hammer.

• Checking, refer to --> [ Outer CV Joint, Checking ] Outer CV Joint, Checking.

2 Bolt, 70 Nm + 90° additional turn

• Always replace after removal.

Vehicle must not rest on its wheels when loosening and tightening.

3 Securing ring

• Always replace after removal.

• Insert in axle shaft groove.

4 Thrust washer

• Installed position, refer to --> [ Installed Location of Spring and Thrust Washers for the Outer CV Joint ] Drive Axle, with CV Joint VL107 Installed on Stub Shaft

5 Dished washer

• Installed position, refer to --> [ Installed Location of Spring and Thrust Washers for the Outer CV Joint ] Drive Axle, with CV Joint VL107 Installed on Stub Shaft

6 Clamp

• Always replace after removal.

• Tensioning, refer to --> [ Tensioning Clamp for Outer CV Joint Boot ] Drive Axle, with CV Joint VL107 Installed on Stub Shaft

7 Outer CV joint boot

• Check for tears and scuffing.

• Material: Hytrel (Polyelastomer).

8 Clamp

• Always replace after removal.

• Tensioning, refer to --> [ Tensioning Clamp for Inner CV Joint Boot ] Drive Axle, with CV Joint VL107 Installed on Stub Shaft

9 Axle shaft

10 Clamp

• Always replace after removal.

• Tensioning, refer to --> [ Tensioning Clamp for Inner CV Joint Boot ] Drive Axle, with CV Joint VL107 Installed on Stub Shaft

11 Inner CV joint boot

• Material: Hytrel (Polyelastomer).

• Without ventilation bore.

• Check for tears and scuffing.

12 Securing ring

• Always replace after removal.

• Insert in axle shaft groove.

13 Clamp

• Always replace after removal.

• Tensioning, refer to --> [ Tensioning Clamp for Outer CV Joint Boot ] Drive Axle, with CV Joint VL107 Installed on Stub Shaft

14 Inner CV joint

• Replace only as complete unit.

• Removing, refer to --> [ Removing the Inner CV Joint ] Drive Axle, with CV Joint VL107 Installed on Stub Shaft

• Installing: Drive CV joint onto the axle shaft until seated using a plastic hammer.