Selector Shaft Lever Seal, Replacing

Selector Shaft Lever Seal, Replacing

Special tools, testers and auxiliary items required

• Tube (VW 423)

• Pulling hook (T20143)

• Torque wrench (V.A.G 1331)

- Remove selector lever cable from transmission --> [ Selector Lever Cable ] Removal and Replacement.

- Carefully pry lever - A - from selector shaft.





- Pry out seal using Pulling Hook (T20143/1)





- Lightly oil new seal on outer circumference.

- Fill area between sealing lip and dust lip halfway with sealing grease (G 052 128).

- Drive new seal to stop; be sure not to distort seal - arrow -.





- Install lever and tighten to 20 Nm.

• Lever of selector shaft fits on to splines only in one position.

- Install selector lever cable on transmission and adjust --> [ Selector Lever Cable ] Removal and Replacement.