Rear Level Control System Sensor

Rear Level Control System Sensor

Special tools, testers and auxiliary items required

• Torque wrench (VAG 1410)

Removing

- Disconnect electrical connector - 1 -.





- Remove the bolts - 2 - from the lower transverse link.

- Remove bolts - arrows - from the subframe.

- Remove the left rear level control system sensor.

Installing

Installation is performed in the reverse order of removal. Observe the following when doing so:

The left rear level control system sensor lever must point toward the outside of the vehicle.

- After replacing, perform a headlamp basic setting. Refer to --> Vehicle Diagnosis, Testing, and Information System VAS 5051 in "Guided Fault Finding" function.

Tightening Specifications