Level Control System Sensors

Level Control System Sensors

There is a Left Front Level Control System Sensor (G78) on the front axle and a Left Rear Level Control System Sensor (G76) on the rear axle.

If the Left Front Level Control System Sensor (G78)/Left Rear Level Control System Sensor (G76) is replaced, check the values. Refer to --> [ Level Control System Sensors, Checking ] Testing and Inspection. Then perform a basic setting on the head lamps.

Headlamp basic setting cannot be performed if the values for the Left Front Level Control System Sensor (G78)/Left Rear Level Control System Sensor (G76) are outside of the tolerance.

--> [ Left Front Level Control System Sensor ]

--> [ Left Rear Level Control System Sensor ]

Left Front Level Control System Sensor

CAUTION!
• Turn off the ignition and all electrical consumers.

• Remove ignition key.

Removing

- Disconnect connector - arrow -.





- Remove the nut - 1 -.





- Remove the mounting bolt - 2 - and remove the Left Front Level Control System Sensor (G78) - 3 -.

Installing

Install in reverse order of removal, noting the following:

- Tighten all threaded connections using the specified torques. Refer to --> [ Fastener Tightening Specifications ] [1][2]Lighting and Horns.

- Check the Left Front Level Control System Sensor (G78). Refer to --> [ Level Control System Sensors, Checking ] Testing and Inspection.

- Perform headlamp basic setting.

• If the Left Front Level Control System Sensor (G78)/Left Rear Level Control System Sensor (G76) is replaced, check the values. Refer to --> [ Level Control System Sensors, Checking ] Testing and Inspection. Then, perform basic setting on the headlamps.

• Headlamp basic setting cannot be performed if the values for the Left Front Level Control System Sensor (G78)/Left Rear Level Control System Sensor (G76) are outside of the tolerance.

Left Rear Level Control System Sensor

CAUTION!
• Turn off the ignition and all electrical consumers.

• Remove ignition key.

Removing

- Disconnect connector - arrow -.





- Remove the mounting bolts - 1 - and remove the Left Rear Level Control System Sensor (G76) - 2 -.





Installing

Install in reverse order of removal, noting the following:

- Tighten all threaded connections using the specified torques. Refer to --> [ Fastener Tightening Specifications ] [1][2]Lighting and Horns.

- Check the Left Rear Level Control System Sensor (G76). Refer to --> [ Level Control System Sensors, Checking ] Testing and Inspection.

- Perform headlamp basic setting.

• If the Left Front Level Control System Sensor (G78)/Left Rear Level Control System Sensor (G76) is replaced, check the values. Refer to --> [ Level Control System Sensors, Checking ] Testing and Inspection. Then perform basic setting on the headlamps.

• Headlamp basic setting cannot be performed if the values for the Left Front Level Control System Sensor (G78)/Left Rear Level Control System Sensor (G76) are outside of the tolerance.