Washer Fluid Level Switch: Service and Repair

Windshield Washer Fluid Level Sensor

CAUTION!
• Turn off the ignition and all electrical consumers.

• Remove ignition key.

Removing

- Remove front bumper cover.

- Disconnect harness connector - 1 - from Windshield Washer Fluid Level Sensor (G33).





- Pull Windshield Washer Fluid Level Sensor (G33) - 2 - out of its rubber seal.

- Collect the draining fluid in a suitable container.

Installing

Install in reverse order of removal, noting the following:

- Bleed headlamp washer system after completing assembly work. Refer to --> [ Headlamp Washer System, Bleeding ] Procedures.