Parking Assist Distance Sensor: Service and Repair

Parking Aid


Rear Parking Aid Sensors

Special tools, testers and auxiliary items required

• Release tool (T10345)

Sensors in the rear bumper cover:

• Left Rear Center Parking Aid Sensor (G204)

• Left Rear Inner Parking Aid Sensor (G334)

• Right Rear Inner Parking Aid Sensor (G335)

• Right Rear Center Parking Aid Sensor (G205)

• Due to different software versions, different sensor names may be displayed in the first Parking Aid Control Module (J446) software version. If this is the case, the following allocation applies:

• Left Rear Center Parking Aid Sensor (G204) is Left Rear Parking Aid Sensor (G203)

• Left Rear Inner Parking Aid Sensor (G334) is Left Rear Center Parking Aid Sensor (G204)

• Right Rear Inner Parking Aid Sensor (G335) is Right Rear Center Parking Aid Sensor (G205)

• Right Rear Center Parking Aid Sensor (G205) is Right Rear Parking Aid Sensor (G206)

• Removal and installation of parking aid sensor is performed in the same way for all sensors and is only described for one sensor in the following.

CAUTION!
• Turn off the ignition and all electrical consumers.

• Remove ignition key.

Removing

- Remove the rear bumper cover.

- Disengage retaining tabs - arrows - with ( T10345) and remove sensor with connector connected from bumper cover.





- Disconnect the connector - arrow - in removed condition.





Installing

Install in reverse order of removal.