Wiring

Glow Plug Connectors



Special tools, testers and auxiliary items required

• Pliers (3314)

Removing

CAUTION!
Before removing the glow plug connectors, note the different installation depths for the glow plugs in each cylinder.

- Position the (3314) with the groove - arrow A - on the upper edge of the connector - arrow B - and press together lightly.





CAUTION!
Position the pliers so they do not touch or damage the wire.

Only use the tool shown.

Other tools may be unsuitable and could damage the connector.

If the connector is damaged during removal, the entire wiring harness including the connector must be replaced. A connector cannot be replaced separately.

- Carefully pull the connector off the glow plug in the direction of the arrow with the (3314).





CAUTION!
Do not pull the connector roughly.

The connector on the wire must not be damaged.

Do not squeeze the pliers together too hard or the connector will be damaged.

The connector is covered with a protective sleeve that can be replaced if damaged.

Installing:

- Guide the center contact on the connector - arrow A - into the glow plug socket - arrow B - by hand.





- Press the glow plug connector - 1 - on by hand until it clicks into place.