Information Bus: Service and Repair

Data Bus On Board Diagnostic Interface

• Before removing Data Bus On Board Diagnostic Interface (J533), the work procedure to read out the codes stored in the module must always be performed. Refer to --> [ Instrument Cluster, Adapting ] Testing and Inspection.

CAUTION!
• Turn off the ignition and all electrical consumers.

• Remove ignition key.

Removing

- Remove the driver's side footwell cover..

- Disengage harness connector - 1 - and disconnect it from Data Bus On Board Diagnostic Interface - 2 -.





- Press mounting pins - 3 - together - arrows - and out of holes.

Installing

Install in reverse order of removal.