Ribbed Belt Pulley without Freewheel

Ribbed Belt Pulley without Freewheel

Special tools, testers and auxiliary items required

• Socket (VAS 3310)

• Torque Wrench (V.A.G 1332) (or corresponding 40 - 200 Nm)

Removing

- Remove the generator.

- Clamp the generator at the mounting points in a vise.

- Use the (VAS 3310) to remove the ribbed belt pulley nut from the generator shaft.





Installing

Install in reverse order of removal, noting the following:

- Tighten all fasteners to specified values. Refer to --> [ Generator Tightening Specifications ] Generator Tightening Specifications.