Brake Light Switch, Old Version

Brake Light Switch, Old Version

• Only use the new brake light switches.

• The most noticeable difference is the new brake light switch has a clear rounded end on the plunger head - A -.





Removing

- Remove the trim on the driver's side..

- If necessary, remove the footwell vents.

- Disconnect the electrical connector from the brake light switch.

The brake light switch must only be removed when the plunger is pressed (brake pedal not operated), otherwise the retainer on the brake light switch will be damaged.

- Remove the brake light switch by turning it 45 degrees to the left.

Installing, Adjusting and Locking

Before installing the brake light switch, grease the clear rounded end on the plunger head with polycarbamide grease (G 052 142 A2).

• When installing the brake light switch, the brake pedal must always remain in the rest position. The brake pedal may only be touched with the brake light switch plunger head during the entire assembly procedure.

- Guide the brake light switch through the assembly opening - arrow 1 - and press it against the pedal with the plunger head. Then turn the brake light switch 45 degrees to the right - arrow 2 -, until it noticeably engages.





- Connect the electrical connector to the brake light switch.

- Check the function of the brake lights.

- Install the footwell vent.

- Install the trim on the driver's side..