Left Driver's Side Trim Without Storage Compartment

Storage Compartments, Covers and Trim

Left Driver's Side Trim without Storage Compartment

Removing

• For reasons of clarity, the steering wheel is not depicted in the illustration, it is not necessary to remove it.

- Switch off ignition.

- Remove side instrument panel cover on driver side. Refer to --> [ Side Instrument Panel Covers ].

- Press rotary light switch toward front, rotate it toward right until it stands vertically, now pull it out and disconnect wiring harness.

- Remove steering column trim gap cover from instrument panel. Refer to --> [ Steering Column Trim ]. It is not necessary to remove the complete steering column trim.

- Remove the two bolts - 1 - (1.5 Nm).

- Remove the two bolts - 2 - (1.5 Nm).

- Disengage trim panel - 3 - from instrument panel and disconnect wiring harness from headlamp range control.





Installing

To install, perform the steps used for removal in reverse order.

• When installing, bolts must be installed in the sequence - 1 - and then - 2 - (1.5 Nm).