Sunroof Motor Initialization

Panorama Sunroof, Adapting

NOTE:
- After changing the glass sunroof panel, a motor, the tilt mechanism or the sunshade, an adaptation must be performed for that particular drive.
- Pinch protection is switched off when performing an adaptation.

Adaptation sunroof motor
The ignition is switched on.

The rotary switch must be in the "Sunroof closed" position.







- Pull the rotary switch - 1 - down and hold it in that position during the entire adaptation process (approx. 20 seconds).
- During the adaptation process, the glass sunroof will first close and then retract by approx. 200 mm.
- After the panel closes again, the adaptation process is completed and the switch can be released.

Motor adaptation process for the sunshade
The ignition is switched on.







- Press the close sunshade button - 3 - and hold it in this position during the engine adaptation process (approximately 20 seconds).
- During the adaptation process, the sunshade will first close and then retract by approx. 200 mm.
- After the sunshade has been closed again all the way, the adaptation process is completed and the switch can be released.