Lower B-Pillar Trim

Pillar and Side Trim

Lower B-Pillar Trim

• Removal and installation is described for the left-hand side of the vehicle. Removal and installation for the right-hand side is performed in the same manner.

Removing

- In vehicles with interior monitoring system, switch ignition off.

- Remove sill panel trim. Refer to --> [ Sill Panel Trim ] Service and Repair.

- Remove upper B-pillar trim. Refer to --> [ Upper B-Pillar Trim ].

- Remove the two bolts - 1 - (4 Nm).

- Remove trim - 3 - from door seal piping.

- Remove trim in area of guide - 2 - from mounts in body.

- In vehicles with interior monitoring system, disconnect wiring harness from sensor.





Installing

To install, perform the steps used for removal in reverse order.