Wheel Housing Trim, Sedan

Sill Panel Trim

Wheel Housing Trim, Sedan

• Removal and installation is described for the left-hand side of the vehicle. Removal and installation for the right-hand side is performed in the same manner.

Removing

- Remove seat bench. Refer to --> [ Seat Bench, Sedan ] Rear Seats.

- Remove side upholstery:

• with rear side airbags, refer to--> [ Side Upholstery with Side Airbag ] Rear Seats.

• without rear side airbags, refer to--> [ Side Upholstery without Side Airbag ] Rear Seats.

- Remove the two bolts - 1 - (1.5 Nm).

- Remove clip - 2 - from body flange.

- Pull trim - 3 - from door seal piping - 4 -.

- Pull trim out of mounts in sill panel trim - 5 -.

- Pull out trim in direction of travel under C-pillar trim panel.





Installing

To install, perform the steps used for removal in reverse order.