Sill Panel Trim

Sill Panel Trim

Sill Panel Trim

• Removal and installation is described for the left-hand side of the vehicle. Removal and installation for the right-hand side is performed in the same manner.

Removing

- Remove side upholstery:

• with rear side airbags, refer to--> [ Side Upholstery with Side Airbag ] Rear Seats.

• without rear side airbags, refer to--> [ Side Upholstery without Side Airbag ] Rear Seats.

Sedan

- Remove wheelhousing trim. Refer to --> [ Wheel Housing Trim, Sedan ].Wheel Housing Trim, Sedan

Wagon

- Remove wheelhousing trim. Refer to --> [ Wheel Housing Trim, Wagon ]. Wheel Housing Trim, Wagon

All vehicles

- Pull sill panel trim out of front sill panel and door seal piping.

- Remove guide - 1 - from lower B-pillar trim.

- Pull sill panel trim out of rear sill panel and door seal piping.

- Remove guide - 2 - from lower B-pillar trim.

- Open strap - 3 - and feed seat belt through it.

• Before installing, check securing clips for damage and replace if necessary.





Installing

To install, perform the steps used for removal in reverse order.