Fixed Rear Door Window With Window Guide, Sedan

Fixed Rear Door Window With Window Guide, Sedan

NOTE:
- Removing and installing is described only for the right fixed window with window guide. Removing and installing the left fixed window with window guide is derived accordingly from this.
- When removing and installing door window, spreader pin and spreader plug are also accessible from outside when outer door panel has been removed.

Removing
- Remove outer door panel.
- Remove door window.







- Pull window guide - 4 - out of center bar - 1 - and guide window guide inward.
- Remove bolts - 2 - and - 3 - and slide center bar - 1 - downward - arrow A -.
- Remove center bar - 4 - from seal of fixed door window - arrow B -.







- Disengage window guide - 1 - with fixed door window - 2 - on inside and outside all around from window frame - 4 -.
- Using release tool T10236, disengage retaining tab on guide pin - 3 - in window frame - 4 -.

Vehicles with window guide trim molding
Remove the window guide trim molding - 4 -.

All vehicles







- Remove complete window guide - 1 - with fixed door window - 2 - from window frame - 3 - in - direction of arrow -.







Installing
Installation is performed in the reverse order of removal.







Tightening torque for bolts - 2 - on center bar: 5.5 Nm
Tightening torque for bolt - 3 - on center bar: 4.5 Nm

NOTE: While installing fixed door window with window guide, make sure it is seated evenly (wind noise).