Side Panel Tail Lamps, LED

Side Panel Tail Lamps, LED

The tail lamps with LEDs in the side panel cannot be disassembled further. It contains the following components:

• Left tail lamp bulb (M4) / Right tail lamp bulb (M2)

• Left brake/tail lamp bulb (M21) / Right brake/tail lamp bulb (M22)

• Left Rear Turn Signal Lamp (M6) / Right Rear Turn Signal Lamp (M8)


• Turn off the ignition and all electrical consumers.

• Remove the key.

Removal

- Push the side trim panel to the side.

- Disconnect the connector - 1 -.






- Remove the nuts - 2 - from the tail lamp assembly inside the side panel.

- Remove the tail lamp.

Installation

Installation is performed in the reverse order of removal. Note the following:

- Tighten the threaded connections to the tightening specification. Refer to => [ Side Panel Tail Lamps, LED Overview ] Side Panel Tail Lamps, LED Overview.

• The tail lamp assembly connector must engage audibly in side panel when connecting.

• Connector is locked correctly when locking button is engaged again.

- Check the gap dimensions between the tail lamp assembly and the body after installing the tail lamp assembly.