Side Panel Tail Lamp, Bulbs

Side Panel Tail Lamp, Bulbs


• Turn off the ignition and all electrical consumers.

• Remove the key.

Removal

- Push the side trim panel to the side.

- Disconnect the connector - 1 -.






- Remove the nuts - 2 - from the tail lamp assembly inside the side panel.

- Remove the tail lamp.

Installation

Installation is performed in the reverse order of removal. Note the following:

- Tighten the threaded connections to the tightening specification. Refer to => [ Side Panel Tail Lamps, Bulbs Overview ] Side Panel Tail Lamps, Bulbs Overview.

• The tail lamp assembly connector must engage audibly in side panel when connecting.

- Check the gap dimension to the body after installing the tail lamp assembly.