Connecting Brake Lines from Master Cylinder to Hydraulic Unit

Connecting Brake Lines from Master Cylinder to Hydraulic Unit

On Master Cylinder:





A Primary piston circuit of master brake cylinder to hydraulic unit.
Identification: Pipe bolt with thread M10 x 1.
B Secondary piston circuit of master brake cylinder to hydraulic unit.
Identification: Pipe bolt with thread M12 x 1.
1 Hydraulic unit to front left brake caliper.
3 Hydraulic control unit to rear right brake caliper.
4 Hydraulic control unit to rear left brake caliper.

On Hydraulic Unit:





A Hydraulic unit to primary piston circuit of master brake cylinder.
Identification: Identification: tube fitting with M10 x 1 or M12 x 1 thread.


During production, the thread was changed from M10 x 1 to M12 x 1.

B Hydraulic unit to master cylinder secondary piston circuit.
Identification: Pipe bolt with thread M12 x 1.
1 Hydraulic unit to front left brake caliper.
Identification: Identification: tube fitting with M12 x 1 or M10 x 1 thread.


During production, the thread was changed from M10 x 1 to M12 x 1.

2 Hydraulic unit to front right brake caliper.
Identification: Identification: tube fitting with M10 x 1 or M12 x 1 thread.


During production, the thread was changed from M10 x 1 to M12 x 1.

3 Hydraulic control unit to rear right brake caliper.
Identification: Pipe bolt with thread M10 x 1.
4 Hydraulic control unit to rear left brake caliper.
Identification: Pipe bolt with thread M12 x 1.