Clutch Pedal Overview

Clutch Pedal and Hydraulics Overviews

• Obtain the anti-theft code for the radio before disconnecting the battery.

• Disconnect the battery Ground (GND) cable with the ignition turned off.

• When connecting the battery

• Lubricate all bearing areas and contact surfaces.

• Allocate the grease, refer to the parts catalog.





Clutch Pedal Overview





1 Bulkhead

• With the studs for the mounting bracket.

2 Gasket

• Always replace

• Between the bracket and bulkhead,

• Self-adhesive

• Adhere to the mounting bracket.

3 Mounting Bracket

• For clutch pedal mounting.

• Some versions have a sound absorber, refer to.

• Removing and installing, refer to one of the following:

GTI, through 2009, refer to => [ Mounting Bracket ] Clutch Pedal and Hydraulics.

Golf/GTI, from 2010, refer to => [ Mounting Bracket ] Clutch Pedal and Hydraulics.

4 Bolt

5 Over Center Spring

• Removing and installing, refer to one of the following:

GTI, through 2009, refer to => [ Over Center Spring ] Clutch Pedal and Hydraulics.

Golf/GTI, from 2010, refer to => [ Over Center Spring ] Clutch Pedal and Hydraulics.

6 Bushing

7 Pivot Pin

8 Clutch Pedal

• Removing and installing, refer to one of the following:

GTI, through 2009, refer to => [ Clutch Pedal ] Clutch Pedal and Hydraulics.

Golf/GTI, from 2010, refer to => [ Clutch Pedal ] Clutch Pedal and Hydraulics.

9 Mount

• To remove and install, separate the master cylinder form the clutch pedal, refer to one of the following:

GTI, through 2009, refer to => [ Clutch Pedal ] Clutch Pedal and Hydraulics.

Golf/GTI, from 2010, refer to => [ Clutch Pedal ] Clutch Pedal and Hydraulics.

10 Gasket

• Always replace

• Between the master cylinder and mounting bracket.

11 Master Cylinder

• Removing and installing, refer to => [ Master Cylinder ] Clutch Pedal and Hydraulics.

12 Clutch Position Sensor (G476)

• Removing and installing, refer to => [ Clutch Position Sensor ] Clutch Pedal and Hydraulics.

• Can be tested in "Guided Fault Finding" using the vehicle diagnostic tester.

• In "Guided Fault Finding", the clutch position sensor is designated as the clutch pedal switch (F36).

13 Clip

• To remove and install the hose/line assembly, pull the clip out to the stop.

14 Supply Hose

• Rubber on some vehicles.

• GTI, through 2009, made of plastic on some vehicles, refer to.

• Golf/GTI, through 2010, made of plastic, refer to.

15 Self Locking Nut

• 25 Nm

• Always replace

• Quantity: 3

• For the mounting bracket to the bulkhead.

16 Nut

• 25 Nm

• Always replace

17 Jounce Bumper

• For the clutch pedal.

Mounting Bracket with Sound Absorber - arrow -