Starter, 2.0L FSI Turbo, Manual Transmission

Starter, 2.0L FSI Turbo, Manual Transmission

Special tools, testers and auxiliary items required

• Torque Wrench (V.A.G 1331)

• Torque Wrench (V.A.G 1332)

• Spring-type clip pliers (VAS 5024)

Removing

- Disconnect battery. Refer to => [ Battery, Disconnecting and Connecting ] Battery, Disconnecting and Connecting.

- Remove screws - arrows -.





- Disconnect electrical connection - arrow -.





- Loosen spring clamps - arrow - using spring clamp pliers (VAS 5024 A).





- Pull off engine cover upward - arrows -.





- Slide protective cap in - direction of arrow - downward from magnetic switch.





- Remove positive wire - 1 - and disconnect harness connector of terminal 50 - 2 -.





- Remove Ground (GND) wire from starter mounting bolt - arrow -.





- Remove mounting bolt for starter - arrow -.





- Remove noise insulation

- Unscrew mounting nut - 1 - from lower mounting bolt of starter.





- Remove wire retainer - 2 -.

- Remove mounting bolt for starter - arrow -.





- Remove the starter downward and out from the vehicle.

Installing

Install in reverse order of removal, noting the following:

- Tighten all threaded connections to the specification. Refer to => [ Specifications ] Specifications.