Turbocharger and Coolant Return Pipe

Turbocharger Component Overview






Turbocharger and Coolant Return Pipe






1 Gasket

• Always replace

2 Nut

• Tightening sequence, refer to => [ Turbocharger Nut Tightening Sequence
and Specification ].

• Always replace

• Lubricate the studs of the exhaust manifold with hot bolt paste; for the hot bolt paste refer to the Parts Catalog.

3 Bolt

• 20 Nm + 45 degrees (1/8) additional turn.

4 Seal

• Always replace

5 Coolant Return Pipe

6 Bolt

• 9 Nm

7 Turbocharger

• Can only be replaced with the exhaust manifold and pressure unit.

• Removing and installing, refer to => [ Turbocharger ] Turbocharger.

8 Bracket

9 Bolt

• 30 Nm

• Lubricate the bolt with hot bolt paste; for the hot bolt paste refer to the Parts Catalog.

10 Bolt

• 30 Nm

• Lubricate the bolt with hot bolt paste; for the hot bolt paste refer to the Parts Catalog.

11 Nut

• 30 Nm

• Always replace

• Do not loosen to remove the turbocharger.

• Lubricate the studs of the exhaust manifold with hot bolt paste; for the hot bolt paste, refer to the Parts Catalog.

12 Fastening Strip

Turbocharger Nut Tightening Sequence and Specification





- Tighten the nuts - 1 through 5 - in 4 passes as follows:

- 1. Tighten the nuts to 5 Nm.

- 2. Tighten the nuts to 12 Nm.

- 3. Tighten the nuts to 16 Nm.

- 4. Tighten the nuts to 25 Nm.