After-Run Coolant Pump (V51)

After-Run Coolant Pump (V51)

Special tools, testers and auxiliary items required

• Hose Clamps Up to 25 mm Dia. (3094)

• Hose Clip Pliers (VAS 6362)

Removing


Risk of scalding due to hot steam and hot coolant.

• When the engine is warm the cooling system is under pressure.

• Reduce pressure by covering the coolant expansion tank cap with a cloth and carefully opening.

- Open the coolant expansion tank cap.

- Remove the noise insulation.

- Disconnect the electrical connector - 1 - from the after-run coolant pump.





- Place (VAS 6208) under the engine.

- Disconnect the coolant hoses - arrows - together with the hose, clamp off using (3094).

- Remove the coolant hoses from the after-run coolant pump.

- Remove the bolt - 2 - and the after-run coolant pump.

Installing

• Tightening specifications, refer to => [ After-Run Coolant Pump Overview ] After-Run Coolant Pump Overview.

Installation is performed in reverse order of removal, noting the following:

- Check the coolant level.