Ribbed Belt Pulley Without Freewheel

Ribbed Belt Pulley Without Freewheel

Special tools, testers and auxiliary items required

• Socket (VAS 3310)

• Torque Wrench (V.A.G 1332)

Removal

- Remove generator. Refer to 2.0L => [ Generator ] Generator or 3.2L => [ Generator ] Generator.

- Tighten the generator in a vise at the mounting points.

- Use the (VAS 3310) to remove the ribbed belt pulley nut (65 Nm) from the generator shaft.






Installation

Install in reverse order of removal, noting the following:

- Tighten all threaded connections to the specification. Refer to => [ General Tightening Specifications ] [1][2]Specifications.