Rear Wheel Housing Liner Assembly Overview

Rear Wheel Housing Liner Assembly Overview

• The illustration shows a left fender. The right fender is identical.






1 Wheel housing liner

• Material - PP/EPDM

• Removing and Installing, refer to => [ Rear Wheel Housing Liner ] Rear Wheel Housing Liner

2 Bolt

• Quantity: 9

• Tightening specification: 2 Nm

3 Expanding nut

• Quantity: 2

4 Expanding nut

• Gas-tight

• Quantity: 2


Expanding nuts - 4 - are gas-tight and seal the interior from exhaust gases and must be installed in any case.

Expanding nuts - 4 - must be replaced if damaged!