Assembly Information

Assembly Information

• Warm the name plate with a hot air blower (V.A.G 1416).

• If removing the name plate, only use the adhesive remover (D 002 000 10) to remove the adhesive residue.

• Remove any adhesive residue left by the tape using adhesive remover (VAS 6349).

• Make sure the adhesive surfaces are free of dust and grease.

• Apply the name plates immediately after cleaning them.

• Only remove the protective film right before assembly.

• Temperature approx. 70°F (2° C).

• It is not possible to remove the name plate without breaking it.