ABS Mark 60, ABS, EDL, ASR and ESP, from Calendar Week 22.2008

ABS Mark 60, ABS, EDL, ASR and ESP, from Calendar Week 22.2008






1 ABS Control Module (J104)

• Removing and installing => [ Control Module and Hydraulic Unit, Removing ] Control Module and Hydraulic Unit, Removing

2 Inner Torx bolt

• Use new bolts.

• 2 Nm + 0.8 Nm

3 ABS Hydraulic Unit (N55)

• Removing and installing => [ Control Module and Hydraulic Unit, Removing ] Control Module and Hydraulic Unit, Removing

4 Brake line

• Master brake cylinder/primary piston circuit to hydraulic control unit

• Identification: Diameter 6.5 mm and tube fitting with M12 x 1 thread

5 Brake line

• Master brake cylinder/secondary piston circuit to hydraulic unit

• Identification: Diameter 6.5 mm and tube fitting with M12 x 1 thread

6 Brake line

• To left front brake caliper

• Identification: Diameter 5.25 mm and tube fitting with M10 x 1 thread

7 Brake line

• to right front brake caliper

• Identification: Diameter 5.25 mm and tube fitting with M12 x 1 thread

8 Brake line

• to left rear brake caliper

• Identification: Diameter 5.25 mm and tube fitting with M12 x 1 thread

9 Brake line

• to right rear brake caliper

• Identification: Diameter 5.25 mm and tube fitting with M10 x 1 thread

10 Brake Booster

• see => [ Brake Booster and Master Brake Cylinder Overview ] Brake Booster and Master Brake Cylinder Overview

• Removing and installing => [ Brake Booster ] Brake Booster

11 Bracket

• after installing, make sure it fits properly

12 Torx(R) bolt, 8 Nm

13 Rubber insulation

14 Hex bolt, 8 Nm

15 Bracket

16 Rubber insulation

• When installing the mount, make sure the rubber insulation does not push out of the bracket.

17 Hex nut, 20 Nm

18 Heat shield

19 Hex nut, 8 Nm