Rear Window Wiper Arm

Rear Window Wiper Arm

Special tools, testers and auxiliary items required
- Torque Wrench V.A.G 1331

Removing
- Allow the wiper to move to the park position.
- Disconnect battery Removal and Installation.






- Fold cover cap - 1 - of rear window wiper up and unclip it.
- Loosen nut - arrow - but do not remove completely.
- Lift wiper arm and loosen by gently rocking back and forth on shaft until felt to release.
- Remove nut - arrow - and remove the wiper arm.

Installing
- With the ignition on, switch the rear windshield wiper on and off again to move the wiper motor into the park position.







- Insert wiper arm on wiper arm shaft at approximate rest position and hand-tighten mounting nut - arrow -.

NOTE: Only tighten the wiper arm mounting nut - arrow - to the specification after adjusting the park position.

- Set rest position of rear window wiper.