Exhaust Manifold With Attachments Assembly Overview

Exhaust Manifold with Attachments Assembly Overview





1 Gasket

• Replace

2 25 Nm

• Replace

3 Exhaust Manifold

• Coat stud bolts on cylinder head with hot bolt paste

• Remove upward

4 Clip

5 Heat shield

6 10 Nm

7 Oxygen sensor (G39)

• 55 Nm

• Use ring spanner set for oxygen sensor (3337) for removal and installation

• When using an oxygen sensor once again, only use hot bolt paste to grease the thread. Do not let the paste get onto the slits of the oxygen sensor body

• Color of harness connector: Black