ABS Mark 60, ABS, EDL, ASR and ESP, From 06.08

Hydraulic Unit and Brake Booster/Master Cylinder Assembly Overview





1 Anti-lock Brake System (ABS) control module (w/Electronic Differential Lock (EDL) (J104)

• Removing and installing, refer to => [ Control Module and Hydraulic Unit ] Service and Repair.

2 Inner Torx bolt, 2 Nm + 0.8 Nm

• Use new bolts.

3 ABS hydraulic unit (N55)

• Removing and installing, refer to => [ Control Module and Hydraulic Unit ] Service and Repair.

4 Brake line

• Master cylinder/primary piston circuit to hydraulic control unit.

• Identification: 6.5 mm diameter and tube fitting with M12 x 1 threads.

5 Brake line

• Master cylinder/secondary piston circuit to hydraulic unit.

• Identification: 6.5 mm diameter and tube fitting with M12 x 1 threads.

6 Brake line

• To left front brake caliper.

• Identification: 5.25 mm diameter and tube fitting with M10 x 1 threads.

7 Brake line

• To right front brake caliper.

• Identification: 5.25 mm diameter and tube fitting with M12 x 1 threads.

8 Brake line

• To left rear brake caliper.

• Identification: 5.25 mm diameter and tube fitting with M12 x 1 threads.

9 Brake line

• To right rear brake caliper.

• Identification: 5.25 mm diameter and tube fitting with M10 x 1 threads.

10 Brake booster

• Removing and installing, refer to => [ Brake Booster ] Brake Booster.

11 Bracket

• After installing, make sure it fits properly.

12 Torx bolt, 8 Nm

13 Rubber insulation

14 Hex bolt, 8 Nm

15 Bracket

16 Rubber insulation

• When installing the mount, make sure the rubber insulation does not push out of the bracket.

17 Hex nut, 20 Nm

18 Heat shield

19 Hex nut, 8 Nm