Sunroof Glass Panel, Adjusting Height

Sunroof Glass Panel, Adjusting Height

NOTE: The glass panel height adjustment is to be performed after the glass panel has been closed out of sliding position.

Zero position of glass panel for sunroof OK.







- Remove bellows.
- Loosen mounting bolts - 1 - for glass panel of sunroof - 2 -.
- Drive sunroof glass panel into position "open" .
- Drive sunroof glass panel into position "closed" .
- Perform height adjustment for glass panel for sunroof at front and rear on both sides as follows:







Front panel adjustment:

- - a - = 0 to 1 mm lower than roof
- - arrow - = driving direction
- Tighten front bolts to 5 Nm.







Rear panel adjustment:

- - b - = 0 to 1 mm higher than roof
- - arrow - = driving direction
- First tighten center, then rear bolts to 5 Nm.

NOTE:
- To achieve the best possible exterior optical characteristics, make sure that the adjustment on left and right sides is performed as evenly (symmetrically) as possible.
- Glass panel must not be higher than roof at any point at front or lower than roof at any point at rear.


- Install bellows .