ABS Control Module, Coding

ABS Control Module, Coding
^ All functions which could previously be performed with Scan Tool VAG1551 can also be carried out with the Vehicle Diagnostic Testing and Information System VAS5051.
^ When ABS Control Module J104 (w/EDL) is coded with 00000, ABS Warning Lamp K47 and Brake System Warning Lamp K118 flash. An entry is not made in the DTC memory.
^ The ABS Control Module J104 (w/EDL) must be recoded if the vehicle relevant coding is not displayed or the control module has been replaced.

Coding is only possible after the workshop code (WSC) has been introduced into Scan Tool VAG1551.

Test Sequence
- Connect Scan Tool VAG1551 and select (address word 03) brake electronics control module with ignition switched on;.
- Establish engine code.

Indicated on display:

Rapid data transfer HELP
Enter address word XX

- Input 07 for the function "Code control module" and confirm with key Q.

Indicated on display:

Rapid data transfer Q
07 - Code control module

- Confirm input with Q key.

Indicated on display:

Coding control module Q
Enter code number XXXXX (0-32000)

- Enter the relevant code number for this vehicle and confirm with Q key.

Control module identification is displayed on display of Scan Tool VAG 1551, e.g.:

1C0 907 379E ESP FRONT MK 60 0103 ->
Coding 0019970 WSC XXXXX