DTC Memory, Erasing and Ending Output

DTC Memory, Erasing and Ending Output

Note:
^ All functions that have so far been carried out with Scan Tool VAG1551 can now also be carried out with the Vehicle Diagnostic Testing and Information System VAS5051.

Requirements
^ DTC memory checked.

1. DTC Memory, Erasing

- Press arrow right key.

Indicated on display:

Rapid data transfer HELP
Enter address word XX

- Press keys 0 and 5 ; 05 enters the "Erase DTC memory" function.

Indicated on display:

Rapid data transfer Q
05 Erase DTC memory

- Confirm entry with key Q

Indicated on display:

Rapid data transfer ->
DTC memory is erased!

- Press arrow right key.

Indicated on display:

Rapid data transfer HELP
Enter address word XX

Indicated on display:

Warning!
DTC memory was not interrogated.

Note:
^ Adhere exactly to test sequence: First check DTC memory, then erase

2. 2. Ending Output
- Press keys 0 and 6, this ends the output.

Indicated on display:

Rapid data transfer Q
06 End output

- Confirm input with key Q.

Indicated on display:

Rapid data transfer HELP
Enter address word XX

- Switch off ignition.
- Disconnect connection to Scan Tool VAG1551.
- Switch on ignition.

ABS Warning Lamp K47 must go out after approx. 2 seconds.