ABS Warning Lamp

ABS Warning Lamp





^ If the ABS Warning Lamp K47 - 1 - does not go out after switching the ignition on and completion of the test sequence, the malfunction may be:

- a - Voltage supply is below 10 Volt

- b - There is a malfunction in the ABS

The anti-locking brake system remains switched off with an ABS malfunction - b -, but the brake system remains fully operational.

Check Diagnostic Trouble Code (DTC) memory.

- c - Since the last time the vehicle was started there was a temporary speed sensor malfunction.

In the case of sensor malfunction - c - the ABS Warning Lamp K47 will extinguish after restarting the engine and attaining a speed of above 20 km/h (approx. 13 mph).

- d - The connection from instrument cluster to ABS Control Module J104 (w/EDL) is interrupted (open circuit).

- e - Instrument cluster is faulty.