Comfort System, Power Windows DTC Memory, Checking, Function 02

Comfort System, Power Windows DTC Memory, Checking, Function 02

NOTE: The vehicle system tester VAG1552 can be used instead of the scan tool VAG1551 or the vehicle diagnostic, testing and information system VAS5051, however a print-out is not possible.

- Connecting VAG1551 or VAS5051 - Scan Tool, Connecting and initiating On Board Diagnosis (OBD) - Comfort System OBD, with Power Windows, Initiating.
- Switch on printer with Print button (warning lamp in button lights up) if using VAG1551 or print via the print menu when using VAS5051, if necessary.

Indicated on display:

Rapid data transfer HELP
Select function XX

- Press buttons 0 and 2. (Function "Interrogate DTC memory" is selected with 02).

Indicated on display:

Rapid data transfer Q
02 - Interrogate DTC memory

- Press Print button.
- Confirm entry with Q button.

The number of stored malfunctions (Diagnostic Trouble Codes (DTC)) appears in the display.

X faults recognized.

The stored malfunctions will be displayed and printed out one after the other.

NOTE:
- If a malfunction is recognized:
- 1. Repair malfunction
- 2. Erase DTC memory (function 05)
- 3. Check DTC memory again (function 02).

- The malfunctions printed out can be diagnosed with aid of Diagnostic Trouble Code (DTC) table, from - Comfort System, Power Windows, OBD DTC Table.
- The function "Read measured value block", - Comfort System, Power Windows, OBD Measured Value Block, Reading, Function 08, and Display group from - Comfort System Display Group Overview, 2nd Generation Vehicles, through 05.01 are additional aids.

The measured value block is divided into 16 display group numbers. The assignment of the individual display zones can be taken from the display group overview from - Comfort System Display Group Overview, 2nd Generation Vehicles, through 05.01.

If "No fault recognized" is displayed the program will return to the initial position after pressing the arrowright button.

No fault detected; arrowright

Indicated on display:

If something else is displayed:
Refer to scan tool operating instructions.

- Press keys 0 and 6 to end the output.

Indicated on display:

Rapid data transfer Q
06 End output

- Confirm entry with Q button.

Indicated on display:

Rapid data transfer HELP
Enter address word XX

- Switch off ignition and disconnect diagnostic connection.