Instrument Cluster, From 06.99

DTC Table

NOTE:
- The following table lists all malfunctions, with the corresponding 5 digit code numbers, that can be recognized by the instrument cluster control module J285 insert and printed out by the scan tool VAG 1551 .
- If malfunctions do not occur regularly, these are displayed as occurring sporadically ("SP").
- DTC codes appear only on printout.
- Before replacing components, check the wiring and connections to these components as well as ground connections, according to wiring diagram.
- When repair has been carried out, Diagnostic Trouble Code (DTC) memory must always be erased and checked again with scan tool VAG 1551 .
- If there is a specific complaint and no malfunctions are recognized after checking Diagnostic Trouble Code (DTC) memory, carry out function 03, "Output Diagnostic Test Mode (DTM)", or function 08, "Read measuring value block". Function 03 - Output Diagnostic Test Mode Function 08- Read Measuring Value Block