Head Lamps, Checking Adjustment with Test Screen without 15 Adjustment Line

Head Lamps, Checking Adjustment with Test Screen without 15 Adjustment Line

Headlamps:

Observe the following:

- With the dipped beam switched on check whether the horizontal light-dark border of the setting line - 1 - contacts the test surface.






- whether the break-away point - 2 - between the left horizontal part and the rising part on the right of the light-dark border runs vertically through the central point - 3 -. The bright core of the light beam must be on the right of the vertical line.

• To make it easier to find break-away point - 2 - cover and uncover left half of headlamp (as viewed when looking forward) a few times. Then check dipped beam again.

• After correct adjustment of dipped beams the center point of the main beam must lie on the center mark - 3 -.

• For the previous test screens with 15° setting line, adjust for new test screen. To avoid incorrect settings, ignore 15° setting line.






Fog Lights






- Check whether the upper light-dark border touches the setting line and runs across the complete test screen width horizontally.

Other Additional Head Lamps

Accessory auxiliary headlamp systems must be checked and adjusted according to the guidelines valid for them.