Door Window

Door Window

• Removing and installing is described only for the right door window. Removing and installing the left door window is derived accordingly from this.

Removing

• Bolt - 3 - is accessible from inside and outside. The bolt as viewed from the outside has a right-hand thread. This means: seen from the outside, bolt is loosened by turning toward left, seen from the inside, bolt is loosened by turning toward right.

- Removing front door trim.

- Pry out cover caps - 4 -.

- Lower door window - 1 - until locking screws - 3 - for mount - 2 - are accessible.

• If the work step is not possible due to a malfunction via the electrical window regulator, window regulator motor can be unscrewed to be able to slide window down.


Loosen screw - 3 - from inside by turning toward right.

- Loosen bolts - 3 - (do not remove) from inside by turning toward right and press apart clamping brackets.





- Raise rear door window - 1 - and swivel out of door toward front in - direction of arrow -.





Installing

- Insert door window - 1 - into door in - direction of arrow -.





Make sure that door window - 1 - is inserted correctly in window guide.

- Now bolt must be tightened by turning toward left.

Tightening specification for bolt: 8 Nm

Further installation is in reverse order of removal.

- Perform function test.