Camshaft Adjustment Valve 1

Camshaft Adjustment Valve 1

Special tools, testers and auxiliary items required

• Ratchet insert 1/4" (VAS 6234)

• TORX(R) bit set (VAG 1766)

• Spring type clip pliers (VAS 5024A)

• Torque wrench (5-60 Nm) (VAG 1783)

Removing

- Disconnect the electrical connector - 1 -.





- Remove the wiring harness from the bracket - 2 -.

- Remove the harness bracket bolt - 3 -.

• Do not pull out the camshaft adjustment valve by the connector.

- Remove the camshaft adjuster valve bolts - arrows - and remove the valve from the housing.





Installing

• The camshaft adjustment valve as well as the housing must be free of dirt and contamination.

• Remove the new camshaft adjustment valve from the packaging only prior to installation.

CAUTION!
• The camshaft adjustment valve must not be subjected to knocks and impacts.

- Lubricate the seal with engine oil.

- Carefully install the camshaft adjustment valve into the housing and press it in by hand until seated.

- Tighten the bolts.

• Tightening specification: 4 Nm.

The rest of the assembly is basically a reverse of the removal sequence.