Right Stub/Flange Shaft and Seal

Right Stub/Flange Shaft and Seal

Special tools, testers and auxiliary items required

• Pressure Piece (3377)

• Torque Wrench (V.A.G 1331)

• Torque Wrench (V.A.G 1332)

• Sealing Grease (G 052 128 A1)

• Grease (G 052 735)

Removing

- Remove the right wheel.

- Remove the noise insulation.

- Remove the right drive axle.

Vehicles With a Intermediate Shaft

- After removing the right drive axle - A -, remove the intermediate shaft to mounting bracket bolts - arrows - and pull off from the stub shaft.





Continuation for All Vehicles

- Place an appropriate receptacle underneath the transmission.

- Remove the stub/flange shaft bolt - arrow -.





- Remove the stub or flange shaft together with the compression spring.

- Pry out the seal.

Installing

- Lightly oil the new seal on the outer circumference.

- Fill the area between the sealing lip and dust lip halfway with sealing grease (G 052 128).

- Using (3377), drive the new seal in until seated, be sure not to distort the seal.





- Instal the stub or flange shaft.

- Install the new bolt and tighten it to 30 Nm.

Vehicles With a Intermediate Shaft

- Replace the O-ring on the stub shaft.

- Grease the splines on the stub shaft using grease for clutch disc splines (G 000 100).

- Guide the intermediate shaft - B - through the mounting bracket - C - onto the transmission stub shaft.





- Tighten the intermediate shaft to mounting bracket bolts - arrows -.

Continued for all vehicles

- Install the right drive axle.

- Install the right wheel.

- Change the Direct Shift Gearbox oil. Refer to => [ Oil Filter and Oil Level, Changing and Adjusting ] Testing and Inspection.

- Install the noise insulation.