Oil Filter: Service and Repair

Oil Filter, Cooler and Pressure Switch Overview






1 Accessory Bracket

• Removing and installing, refer to => [ Accessory Bracket ] Service and Repair.

2 Oil Pressure Switch (F1)

• 20 Nm

• 1.4 bar - Black

• Checking, refer to => [ Oil Pressure and Switch, Checking ] Testing and Inspection.

• Remove using socket 24 mm and jointed extension (T40175).

3 Gasket

• Always replace

4 O-ring

• Always replace

5 O-ring

• Always replace

6 Valve Unit

7 Oil Filter Element

• 22 Nm

• Remove and install using oil filter wrench (3417).

8 Bolt

• 15 Nm

9 Connection

10 Seal

• Always replace

11 Oil Cooler

• See note, => [ If large quantities of metal particles
or abraded material are detected during engine repairs, it may mean
the crankshaft or rod bearings are damaged. To prevent further damage,
perform the following steps after the repair: ] Oil Pan and Pump Overview.

• Ensure sufficient clearance to surrounding components.

• Coolant hose connection diagram. Refer to => [ Coolant Hose Connection Diagram ] [1][2]Diagrams.

• Removing and installing, refer to => [ Oil Cooler ] Service and Repair.

12 Gasket

• Always replace

13 Bolt

• Tightening sequence, refer to => [ Accessory Bracket Bolt Tightening Sequence
and Specification ] Ribbed Belt Overview.