Assignment Of Sensor Bracket To Component Location In Bumper Cover

Assignment Of Sensor Bracket To Component Location In Bumper Cover

Sensor brackets are designed in different shapes and must be matched to the respective component location in the bumper cover. To simplify assignment, the sensor brackets are marked on the inside with a letter - arrow -. Each sensor bracket also has two code tabs - 1 - which mate to the component location. Observe the alignment of sensor connections in the respective assignment.






Sensor Bracket Assignment On Inside Of Rear Bumper Cover

• Codes D, E, F, and G are located on the sensor brackets.

• Codes C, B, and A are located on the inside of the bumper if there are no holes in the bumper cover.






Bracket (D) - left outer at position I on the bumper

Bracket (E) - left center at position A on the bumper

Bracket (F) - right center at position B on the bumper

Bracket (G) - right outer at position C on the bumper