Body - Convertible Top, Center Section Rattle Noise

61 11 01

May 3, 2011

2024262 *Supersedes T.B. V611002 dated Nov. 19, 2010 to adjust locking fluid quantity.*

* Updated information is noted by asterisks and in yellow *





Vehicle Information

Condition

Convertible Top, Center Section Rattle Noise

Technical Background





M-Segment (1) fasteners (5) may not be fully seated.

Production Solution

Not applicable.

Service





^ Lower rear headliner. See Repair Manual Group 61 Convertible Top, Tensioned Headliner





^ Remove headliner support (qty. 5 fasteners).





^ Check M-Segment fasteners (qty. 6, 3 per side), shims and washers for movement.

^ For each fastener that shims and washers are loose, remove fastener and inspect threads for damage. Replace any damaged fasteners.

^ Apply Locking Fluid Part No. D000600A2 to threads and tighten fastener to 7 ft. lbs. (9.5 NM).





Removing Middle and Rear Fasteners

To remove the middle and rear fasteners place roof in service position shown. Use special tool Part No: VAS6365, Hinge Supports -arrow-.

^ Prepare hinge supports by pinning them in the fully extended position.

^ Open roof with Convertible Top Operation Switch -E137- until it is just before the position shown.

^ Place hinge supports in mounting holes of main hinge.

^ Switch ignition off, roof lowers in stages until longmembers are resting on supports.








Warranty





Required Parts and Tools

Additional Information

All part and service references provided in this Technical Bulletin are subject to change and/or removal.
Always check with your Parts Dept. and Repair Manuals for the latest information.