Glass Panel For Sliding/Tilting Sunroof, Installing

Glass Panel For Sliding/tilting Sunroof, Installing

- Panel must be installed in zero position (panel closed).

Zero position:







Marking - arrow - on upper part of rear guide - 1 - must be located on both sides between markings dimension - a - at slotted guide rail - 2 -.

Link guide - 2 - must be engaged in guide rail (cannot be moved by hand).

If this is not the case, adjust parallel movement







- Insert glass panel for sunroof - 2 - from above and screw in mounting bolts - 1 -.
- Tighten mounting bolts - 1 - lightly.
- Adjust glass panel for sunroof (height adjustment):

NOTE:
- Tighten bolts after panel height adjustment (4.5 Nm).
- Install boots after panel height adjustment.