FREE REPAIR MANUALS & LABOR GUIDES 1982-2013 Vehicles
Courtesy of Operation CHARM: Car repair manuals for everyone.

Antitheft - No Start Below 4 Degrees C. (Canada)

Group: 90

Number: 05-07

Date: November 18, 2005

Subject:
Immobilizer Activated If Ambient Temperature Is Below 4°C (40°F)

Model(s):





New Beetle, New Beetle Convertible 2006
Canada Only (See Table)

Condition

An intermittent No Start condition may exist in ambient temperatures below 4°C (40°F):

^ The vehicle cranks but does not start after sitting for long periods or over night

^ The electronic immobilizer light is flashing

^ The vehicle cannot be started with any of the keys

When the concern can be reproduced the following fault codes may be present:

^ P1570 in 01 - Engine Electronics

^ 01176 in 25 - Immobilizer

Tool Requirements:

VAS 5051/5052 or VAS 5051 B scan tool with GEKO

Service





- Verify if the instrument cluster has already been updated:

- Tilt the steering wheel down in order to see the white label on the bottom of the instrument cluster.

^ If the letter "C" is printed on the label the part has already been updated

^ If the letter "C" is not on the label, a new instrument cluster has to be ordered for the vehicle based on the Vehicle Identification Number (VIN)

Note:
If the condition exists, and the instrument cluster has been updated, follow normal diagnostic procedures.

- Replace the instrument cluster with one of the following, see Repair Manual Group 90 - Instruments for procedure

^ 1C0 920 501 B 1.9L diesel engine, manual transmission

^ 1C0 920 501 L 1.9L diesel engine, automatic transmission

^ 1C0 920 501 N 2.5L gas engine, manual transmission

^ 1C0 920 501 P 2.5L gas engine, automatic transmission

Tip:

The updated clusters will have the same part number as the old part however they will be marked with the letter "C" as mentioned above.

- Make note of the odometer mileage of the vehicle.

- Replace the instrument cluster and adapt it using the GFF plan.

- Verify the correct odometer mileage setting of the new instrument cluster after the replacement.

Note:
It may take up to 6 attempts to program the instrument cluster. If after 6 attempts instrument cluster does not program, contact the Volkswagen Dealer Technician's Helpline.