Transmission Housing and Selector Mechanism, Removing and Installing

Transmission housing and selector mechanism, removing and installing, 02M, 5 and 6 Spd. M/T





1 - Countersunk head bolt, 25 Nm
2 - Flanged shaft with spring

3 - Back-up light switch, 20 Nm
4 - Oil seal
^ Always replace

5 - Oil drain plug, 30 Nm
^ Always replace

6 - Oil seal
^ Always replace

7 - Cover plate
8 - Hex bolt, 20 Nm
^ Always replace

9 - Hex bolt, 20 Nm
^ For selector shaft item 14 to cover plate
^ Always replace

10 - O-ring
^ Always replace
^ Insert in groove in cover plate

11 - Locking bolt, 15 Nm
^ For selector shaft gate
^ Always replace
^ Insert with locking fluid D 000 600 A2

12 - Hex bolt, 25 Nm plus 1/8 turn (45°) further
^ With attached washer
^ Always replace

13 - Hex bolt, 25 Nm plus 1/8 turn (45°) further
^ Without washer
^ Always replace

14 - Selector shaft
15 - Hex bolt, 20 Nm
^ Always replace

16 - Selector mechanism cover
17 - Clutch housing
18 - Transmission housing