Shift Interlock Cable: Adjustments

Locking cable, adjusting, 01M, 4 Spd. A/T

WARNING! Adhere strictly to the description below for the adjustment of the locking cable.

Requirements
^ Locking cable correctly fitted
^ Center console removed.
^ Selector lever in position "P"
^ Ignition key withdrawn.

Work sequence





- Slide sliding sleeve -1- forward.
- Release clip -2- by pressing upward.





- Pull off connector -4-.
- Remove sleeve -5- upward.
- Release selector lever housing cover at retaining lugs -6- (Qty. 4) by hand and lift off.
- Carefully pry off four corners of frame -7- and remove.





- Slide 0.8 mm feeler gauge between locking lever and selector lever roller.
- Pull locking cable outer sleeve lightly forward in direction of travel (arrow -1-) and push red clip downward until it engages (arrow -2-).
- Push sliding sleeve over clip.
- Check operation of ignition key withdrawal lock.