Power Trunk / Liftgate Lock Actuator: Locations

Rear Lid Lock, Removing and Installing







1. Locking clamp
2. Handle

- Removing
- Unclip lid trim (handle is secured with a bolt).
- Unclip pull lever , pry out locking clamp and remove lock cylinder housing from handle.
- Disconnect connector for luggage compartment light and unclip operating rod for central locking system if necessary.
- Remove Torx bolts and remove handle from lid.

3. Actuator securing bolt
- Loosen and tighten using Socket wrench T10010
4. Central locking actuator

- Removing
- Disconnect connector from actuator.
- Remove actuator using Socket wrench T10010 and remove from lid.

5. Pull lever
6. Torx screw
7. Operating rod
8. Lock cylinder housing

- Removing
- Unclip lid trim (handle is secured with a bolt).
- Unclip pull lever , pry out locking clamp and remove lock cylinder housing from handle.

9. Lock

- Removing
- Remove lid trim.
- Disconnect connector from lock.
- Unclip operating rod , remove bolt and remove lock from lid.

- install - only with striker catch in detent
10. Oval-head machine screw
- 20 Nm
11. Actuator lever

Installing
- Engage locking clamp again.
- Position lock cylinder housing on to grip piece and lock in handle with an audible click.
- Then proceed in reverse order of removal.